New Front and Rear 1350 Series Jeep JK Wrangler Driveshaft 4 Door with Solid cross/Gold series U-Joints, Pinion Flange (front), Pinion Yoke (rear), Transfer Case Flanges (front and rear) and hardware
\n
\n
Application:
\n
\n
2007 – 2018 Jeep JK Wrangler: 4 door models
\n
\n
We build all front and rear JK driveshafts to the same measurements respectively. We guarantee the measurement up to a 4 inch lift. If you have a lift over 4 inches we would require a measurement. Each lift kit is different, so just to be sure we build the perfect driveshaft for you, we offer $10 off your purchase with a custom measurement. Please use code 10off along with your measurement with the Jeep sitting on the tires ride height.
\n
\n
Product Description:
\n
\n
FRONT DRIVESHAFT: We build each front 1350 series driveshaft with 2” x .120 wall tubing (which is double the strength of the OEM tubing), 1 1/2” slip and spline, solid cross/non-greaseable U-Joints, pinion flange, transfer case flange and hardware (pinion flange bolts will be reused).
\n
**Our front driveshafts come with a 4 bolt pinion flange to bolt directly to OEM flange, which eliminates the need to remove the OEM flange and causing any damage to crush sleeve.**
\n
REAR DRIVESHAFT: We build each rear 1350 series driveshaft with 3” x .083 wall tubing (which is double the strength of the OEM tubing), 1 1/2” slip and spline, solid cross/non-greaseable U-Joints, pinion yoke, transfer case flange and hardware.
\n
**Rear pinion flange will need to be removed and included pinion yoke will need to be installed.**
\n
We use all components from Spicer, NEAPCO, and Powertrain Industries.
\n
\n
\n
\n
CA Residents: 
WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov
\n
\n
